Toilet Repair & Replacement in Grand Junction, CO
Running toilets, weak flushes, leaks at the base and full replacements for homes and businesses across the Grand Valley.
A toilet that runs, leaks or will not flush right is a small problem that gets expensive if you ignore it. GPS Plumbing & Mechanical repairs and replaces toilets for homes and businesses in Grand Junction, Fruita, Palisade, Clifton and across Mesa County.
Most toilet repairs are simple and quick when you know what to look for. We will tell you honestly whether a repair is worth doing or whether a new toilet is the better value, and the price goes in writing before work starts.
Serving Grand Junction, Fruita, Palisade, Clifton, Delta, Montrose, and the rest of Mesa County.
What's included
- Running toilet repair, including flappers, fill valves and flush valves
- Clogged and slow-draining toilet service
- Leaks at the base, supply line and tank bolts
- Wax ring replacement and resetting a loose toilet
- Toilet replacement and new toilet installation
- Shut-off valve and supply line replacement
Signs you need this
- The toilet runs on or refills every so often on its own
- A weak flush or a toilet that clogs often
- Water on the floor around the base
- A toilet that rocks or wobbles
- Water leaking from the tank or the supply line
- A high water bill with no obvious reason
How a toilet works, and where it fails
A toilet has two main systems. The fill valve refills the tank after a flush and shuts off when the float reaches the right level. The flush valve has a flapper (or seal) at the bottom of the tank that lifts to release water into the bowl, then drops back to hold the water in. The rest is the bowl, the trap and the wax ring that seals the base to the drain flange in the floor.
Most failures come from the rubber and plastic parts, which wear over time, especially in hard water.
- A running toilet is almost always the flapper not sealing, a chain that is too tight or too loose, or a fill valve that does not shut off.
- A weak flush can come from a partly clogged rim jets, a low tank water level, a worn flapper or a partial clog in the trap or drain.
- A toilet that clogs often may have a restricted trap, a drain line problem or an older low-flow design. If more than one drain in the house is slow, see drain cleaning.
- Water at the base means the wax ring or flange seal has failed, the closet bolts are loose, or the toilet is rocking.
- A leak from the tank can be the tank-to-bowl bolts and washers, the supply line connection or a cracked tank.
Why a running toilet matters
A toilet that runs, even slightly, is quietly using water all day. You may not hear it. The easy test is a few drops of food coloring in the tank. If the color appears in the bowl after 15 to 20 minutes without a flush, water is leaking past the flapper. Replacing a flapper is usually a small repair, and it can show up as a lower water bill.
It is also worth knowing where your toilet's shut-off valve is. A valve on the wall or floor behind the toilet stops the water to just that fixture. If a valve is stuck, corroded or leaks when turned, we replace it so you can shut the water off in an emergency.
Toilet replacement: what to think about
- Efficiency. Modern toilets use less water per flush than older models and many flush well. Look for a toilet with a good flush rating, not just a low water number.
- Rough-in. The distance from the wall to the center of the drain is usually 12 inches, but 10 and 14 inch rough-ins exist. The new toilet has to match.
- Height and shape. Comfort-height toilets are taller, and round and elongated bowls differ in size. Check the space in front.
- The flange and floor. When we pull an old toilet we check the flange, the closet bolts and the floor around the base. A soft floor or a damaged flange needs attention before a new toilet goes down.
- New wax ring and supply line. These should be replaced with the toilet, not reused.
If you already have a toilet picked out, we can install it. If not, we can help you choose one that fits the space.
What affects the price
Prices depend on the details, so we don't quote blind. Every job gets a free written estimate before any work starts, so you know the cost up front. Diagnostics are free in the Grand Valley. Outside the Grand Valley, a $79.99 service call fee covers locations up to 50 miles from Grand Junction, plus $2 per one-way mile beyond that. The $79.99 is credited toward the work if you go ahead with the repair; the additional mileage is not credited. Here's what usually drives the cost:
- Whether the fix is a small internal part or a full replacement
- The toilet itself, if you are replacing it, and any special features
- Whether the shut-off valve, supply line or flange also need repair
- Floor damage or a damaged flange found when the toilet is pulled
How it works
Call or request service
Tell us what is going on and we will get you on the schedule.
We diagnose & quote
We diagnose the problem on site and give you a free written estimate.
We do the work
We complete the job, walk you through what we did, and warranty our labor for one year.
Toilet Repair & Replacement questions
Why does my toilet keep running?
Usually the flapper at the bottom of the tank is worn and not sealing, or the fill valve is not shutting off. Both are common, inexpensive parts. A toilet that runs can waste a lot of water, so it is worth fixing.
How do I know if my toilet is leaking inside?
Add a few drops of food coloring to the tank and wait 15 to 20 minutes without flushing. If color shows up in the bowl, water is leaking past the flapper.
Why is there water around the base of my toilet?
It can be a failed wax ring, loose closet bolts, a leaking supply line or shut-off valve, or condensation on the tank. Stop using the toilet until it is looked at, because water under the base can damage the floor.
Should I repair or replace my toilet?
A running or leaking toilet is usually a simple repair. Replacement makes sense when the porcelain is cracked, the toilet clogs constantly, or you want a more efficient model. We will give you both options.
Can you install a toilet I bought myself?
We can install a toilet you supply, but we cannot warranty the toilet itself, and we do not warrant customer-supplied material or equipment. We can also supply one for you.
What if my toilet will not stop overflowing?
Turn the shut-off valve behind the toilet clockwise to stop the water, and call us. If there is a lot of water, shut off the main as well.
Is the work warranted?
Our labor is warranted for one year. Parts and equipment are covered by the manufacturer's warranty. We do not cover or offer a warranty on customer-supplied material or equipment.
Get a free estimate
Free written estimates for toilet repair & replacement, straight answers, and a licensed contractor who shows up when promised.